Houser Racing Slicast Standard Travel A-Arms

Bearing End Break Down

• One grease zerk which moves the grease from the inside to the outside
• 2 dust covers with seals
• 2 needle bearings
• hardened and ground to size bearing sleeve
• 2 grease seals
• 2 hardened thrust washers
• Houser 1-piece delrin bushing
• Unsealed dust cover, unless stock dust cover is used

Slicast™ System

• Positive caster is achieved by rotating the ball joint cam towards the rear of the ATV making the ATV handle better in a straight line, but harder to turn
• Negative caster is achieved by rotating the ball joint cam towards the front of the ATV making it corner better, but twitchy in a stright line

Adjusitng the slicast™ is done in 3 easy steps:

• Back off the jam nut in the front of the upper ball joint
• Pull the Slicast™ piece out 1/8" and rotate it to the desired setting that you want to achieve
• Re-tighten the jam nut. Yess it is that quick and simple