Cart is empty
CODE:
Product Overview I : Programmable FS Ignitions for Quads The Dyna FS for quads is our hottest new product this year. Direct Plug in... More
Unfortunately this combination is not accessable
This CDI increases rev up to 1,000 rpm over stock.
The Pro Armor Kill Switch features a T handle knob for easier pulling to reset the switch and an internal o-ring for proper sealing to prevent contaminants from entering the main body. The durable plastic housing allows for years of abuse. Mounts in minutes with a simple two wire installation.
High performance Rev Limiter enhances the power curve and adds up to 2 hp.
Dyna Coil Kits is now offering high output Mini Coils in a model specific kit with the necessary mounting hardware, wiring adapters and spark plug wire(s) for popular ATV applications.
Direct OE replacements.
Rick's CDI Units
Make your ATV race ready with the Pro Armor kill switch. Mount the kit to your ATV in minutes with simple plug and play installation.
Out preforms any wall plug charger, Maintains full charge indefinately, fully charges battery indefinately.
Plug in performance for your Rhino. Provides a more aggressive advanced timing curve, reduces stock restrictive rev limiter and adds an additional 1000 rpm over stock. Gives a stock Rhino approximately 7-10 mph on top end with better mid range and throttle response.
A must for racing or for any type riding. Kills engine if rider falls off machine. Completely waterproof, has recoil style cord that easily attaches to the rider. Works for ATVs and motorcycles. Tether switch for open to run ignition system. Cap pulled closes circuit and grounds out engine.
Whether it be your personal watercraft, damp or wet garage, basement sump pump, a vehicle under a carport or anywhere outside, the waterproof Battery Tender® will operate anywhere! 100% sealed and extremely durable!
Simultaneously charges and/or maintains up to 10 12V batteries. For the shop with a lot of batteries to maintain.
EMGO 6 & 12 Volt Automatic Economy Charger, Converts to a 6 to 12 volts at the flip of a switch. Switch also has an off position for convenience and a handy disconnect plug for battery leads. .5 amp. Maintains full charge indefinitely. Made in Taiwan.
The Battery Tender® is designed to fully charge a battery and maintain it at proper storage voltage without damaging effects caused by trickle chargers. So easy to use, you just plug it in and forget it. Theres absolutely no fear of boiling or overcharging the battery
Track my order(s):
Cart is empty
Electrical
Electrical
